Epson Stylus Pro 7000 - Mechanism Adjustment

EPSON Stylus Pro 7000 Revision B
Adjustment Mechanism Adjustment 197
5.5 Mechanism Adjustment
This section describes the mechanism adjustments you need to perform
when replacing or removing certain parts. The parts and their corresponding
adjustments are as follows.
Table 5-15. Necessary Mechanism Adjustments
Parts Adjustment Necessary Tools Refer to
CR Motor CR Steel Belt Tension
Tension Gauge #F712
code: 1047744
Standard: 8,000g
page 198
PF Motor PF Belt Tension
Tension Gauge
code: B747700300
Standard: 4,000g
page 198
P THICK
sensor
Self-diagnostic test -
"Paper Thickness"
6/7mm schema gauge(s) page 199
Cover Open
sensor
Self diagnostic test -
"Cover"
- page 200