Epson Stylus Pro 7000 - Page 151

EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Disassembly Flow 151
4.2.3.20 Removing the CR_HP Sensor
1. Remove the R Side Cover as described in “R Side Cover Removal” on
page 114.
2. Push the carriage lock using your finger to unlock the carriage and move
the carriage from the home position to the left.
3. Disconnect the harness from the CR_HP Sensor connector.
4. Release the hook fixing the CR_HP Sensor and remove the CR_HP Sensor.
Figure 4-77. Removing the CR_HP Sensor
Connector
Hooks
CR_HP
Sensor