3. First Step
Safety and Installation (T, VT / EPSON RC+ 7.0) Rev.15 89
4. Run the program
(1) Press F5 to run the program. (F5 is the hot key for the [Run Window]
selection of the [Run] Menu). You will see the Status window
located at the bottom of the main window showing the build operation
status.
(2) During project build, your program is compiled and linked. Then
communications is established with the Manipulator and project files
are sent to the Controller. If there are no errors during build, the Run
window will appear.
(3) Click the <Start> button on the Run window to run the program.
(4) The tasks like the following will be displayed in the status window.
19:32:45 Task main started
19:32:45 All tasks stopped
On the Run window, you will see the output of the print statement.
To Next Page
Loading...
Need help?
General
