Notes
The printer starts operation nx0.1 seconds after detecting
the loading of the paper.
If either m or n is out of the defined range, this command
is ignored and the previously set value is not changed.
Default m = 0, n = 10
ESC P m n1 n2
Name
Format
Range
Description
Generate pulse
< 1B >
H
< 70 >
H
< m >< n1 >< n2 >
m = 0
The pulse set by n1 or n2 is output to the connector pin m.
• m is specified as follows:
m Connector Pin
0
Drawer-kick out connector Pin 2
Default
Reference
• ON time is n1X2 msec, and OFF time is n2X10 msec.
Neither m, n1, nor n2 is defined.
APPENDIX B Connectors
ESC q
Name Release
Format
< 1B >
H
< 71 >
H
Description
Releases the paper.
Notes
• When the panel switches are disabled and a paper detector
which is enabled to stop printing detects a paper-out, the
printer releases the paper regardless of this command.
• Valid only in Standard Mode.
Reference ESC c4, ESC c5
ESC t n
Name
Select character code table
Format
< 1B >
H
< 74 >
H
< n >
Range
-35
To Next Page
Loading...
