Setting Up the Printer 1-17
4. Remove the paper from the printer and feed another sheet of
slip paper into the printer to print characters from the character
table. Continue to feed slip paper into the printer until the self
test prints the following:
***completed***
The printer is ready to receive data as soon as it completes the self
test.
Note:
If you want to pause the self test manually, press the
REVERSE
button. Press the
REVERSE
button again to continue the self
test.
Adjustments and Settings
The TM-H5000II / H5000IIP is set up at the factory to be
appropriate for almost all users. It does, however, offer some
settings for users with special requirements.
It has DIP switches that allow you to change communication
settings, such as handshaking and parity check, as well as print
density and connection to a customer display.
The TM-H5000II /H5000IIP also has a near-end sensor for the
paper in the receipt section. This can give you a warning when the
paper is almost out. If you find that there is not enough paper
remaining on the roll when the near-end sensor is triggered, you
can change the near-end sensor setting.
See Appendix A if you need to make any of these changes.
H5po1r3.fm Page 17 Tuesday, July 14, 1998 12:31 PM
To Next Page
Loading...
Need help?
General