Troubleshooting 3-7
2. Following the instructions on the label, rotate the knob until the
appears in the hole.
3. Close the cutter cover.
Cleaning the Optional MICR Mechanism
MICR cleaning (when the printer is used with a MICR reader)
Use a moistened cleaning sheet for the MICR head. Use an
adhesive cleaning sheet for the MICR feed roller. See the table
below for cleaning frequency.
Note:
If you encounter frequent MICR reading errors, use one of the two
methods described below.
Part to clean Type of cleaning sheet Cleaning frequency
MICR head Moistened cleaning sheet Every 6000 passes or once a
month
MICR feed roller Adhesive cleaning sheet Every 6000 passes or once a
month
H5po3r1.fm Page 7 Tuesday, July 14, 1998 12:33 PM
To Next Page
Loading...
Need help?
General