3-10 Troubleshooting
9. Load the cleaning sheet like a standard check. If you are using
the adhesive cleaning sheet, insert the printed (adhesive) side
up.
CAUTION:
Be sure the printed (adhesive) side is up, and the sheet is
inserted in the right direction.
10. When the sheet is ejected, press the RELEASE button, and
remove the sheet from the printer.
CAUTION:
Do not use a cleaning sheet more than once.
Command mode
1. Send the FS s cleaning command to the printer.
2. Perform steps 8 to 10, as described in self mode.
Hexadecimal Dump
This feature allows experienced users to see exactly what data is
coming to the printer. This can be useful in finding software
problems. When you turn on the hex dump function, the printer
prints all commands and other data in hexadecimal format along
with a guide section to help you find specific commands.
To use the hex dump feature, follow these steps:
1. After you make sure that the printer is off, open the cover.
2. Hold down the FEED button while you turn on the printer.
3. Close the cover.
H5po3r1.fm Page 10 Tuesday, July 14, 1998 12:33 PM
To Next Page
Loading...
Need help?
General