4-8 Reference Information
❏
Since the TOF sensor uses a reflective photo sensor and it
detects from the back of slip paper, do not use paper that has
holes or dark portions with low reflection (less than 40%
reflection) at the sensor position.
❏
Use thinner paper (N30 or equivalent) between the top and
bottom sheets of multi-ply paper. If thick paper is used, the
copy capability is lowered.
[ All the numeric values are typical. ]
31
8
18.9
38.5
18
39
21.9
1.8
37.2
3.6
Form stopper position
Slip feeding roller
position
TOF sensor
position
Center of the print head
MICR head
Slip side guide
BOF sensor
Paper feed direction
1.3
15
24
10
Paper holes and translucence
prohibited area.
Area where paper holes are prohibited
and reflection rate for the back of
paper should be 40% or more.
Paper feed direction
[Units: mm (All the numeric values are typical.)]
H5po4r3.fm Page 8 Tuesday, July 14, 1998 12:33 PM
To Next Page
Loading...
Need help?
General