103
Appendix
Slip paper
Notes on slip paper
The slip paper must be flat and without curls, folds (especially curls or folds at the top edges), curves, or
wrinkles. Otherwise, it may rub against the print head surface and become dirty.
Because the BOF sensor uses a transmission photo sensor, do not use paper that has holes at the sensor posi-
tion or is translucent.
The TOF sensor uses a reflective photo sensor and detects from the back of the slip. Do not use paper that
has holes or dark portions with low reflection rates (40% or less) at the sensor position.
Paper types Normal paper
Paper size 68–230 mm {2.68–9.06"} (width) × 68–297 mm {2.68–11.7"} (length)
The minimum size is 68 × 152 mm {2.68 × 5.98"}.
Paper thickness 0.09–0.2 mm {0.0035–0.0079"} (only single-ply can be used)
100 mm {3.94"}
10 mm {0.39"}
48 mm {1.89"}
82 mm {3.23"}
8 mm {0.31"}
15 mm {0.59"}
8 mm {0.31"}
Paper holes and
translucence
prohibited in this area
Paper holes prohibited
in this area
Paper feed direction
All the numeric values are typical.
To Next Page
Loading...
