26
Changing the Roll Paper Width
This printer allows for the paper width of the roll paper to be changed. It can be selected from four types: 57.5
mm {2.26"}, 69.5 mm {2.74"}, 76 mm {2.99"}, and 82.5 mm {3.25"}. (The default is 76 mm {2.99"}.)
Follow the procedure below to change the paper width.
1
Make sure the printer is turned off.
2
Open the Roll paper cover by pressing the cover open button.
3
Remove the screw holding the roll paper guide located on the left side of the roll
paper holder.
When changing the paper width, be sure to change the setting for the paper width by using the
TM-J7200 TM-J7700 Utility or customize value. (See "Customize Value Setting Mode" on page 54
)
Do not change to wider paper width after using a narrower paper width. The autocutter blade may
be worn and may not be able to cut cleanly.
To Next Page
Loading...
