46
Ethernet setting mode
This function initializes Ethernet interface settings.
Follow the procedure below for initialization.
1
With the Front cover/ Roll paper cover closed, turn the printer power on while press-
ing the Feed button until printing of the printer status starts.
2
After the printer status is printed, press the Feed button until printing of the instruc-
tions for operation method starts.
3
After the instructions for operation are printed, briefly press the Feed button three
times.
4
Then, press and hold the Feed button until Ethernet setting mode starts.
5
The printer prints the setting instructions. Perform settings in accordance with the
instructions.
6
After finishing the setting, turn off the printer.
To Next Page
Loading...
