90
Setting slip paper does not start printing
Check the Cut sheet LED.
Cut sheet LED is flashing continuously
Waiting for insertion of slip paper.
Cut sheet LED repeats a double-flashing pattern
Cut sheet LED is off
Paper jam
Cause Solution and reference
The slip paper is set in a incorrect posi-
tion.
Check whether the slip paper is inserted straight along the paper guide.
If the paper is inserted at an angle, misalignment may occur in the print result.
Cause Solution and reference
A new slip paper was inserted before the
printed slip paper was removed.
Remove both the printed slip paper and the new slip paper. When the cut
sheet LED stops a double-flashing pattern, insert the new slip paper.
Cause Solution and reference
Roll paper is set as the paper source.
The slip paper is not ready for printing.
Check the application and change the paper source to slip paper.
Not connected to the computer. Check the interface cable.
Cause Solution and reference
Slip paper jam Open the Front cover and remove the paper.
Roll paper jam Open the Roll paper cover and the Front cover and remove the paper.
To Next Page
Loading...
