Epson TM-J7200 - Page 98

98
Characters per Line and Printable Area for Slips (TM-J7700)
*: With 600 dpi. Parentheses indicate value for 180 dpi.
[cpi: characters per inch (25.4 mm)]
General Print Speed
[lpi: lines per inch (25.4 mm)]
[lps: lines per second]
Print dot count (dots) * 3200 (960) 3257(977)
Right margin (mm) * 4.3 2.0
Print width (mm) 135.6 137.8
Characters per line Font A 80 15 cpi 81 15 cpi
Font B 106 20 cpi 108 20 cpi
Font A, when increasing
number of lines
87 16.3 cpi 88 16.3 cpi
Font B, when increasing
number of lines
120 22.5 cpi 122 22.5 cpi
Special Font A 64 12 cpi 65 12 cpi
Print control mode Font
Roll paper width
TM-J7200/ TM-J7700 (mm)
Slip paper
57.5 69.5 76 82.5 TM-J7200 TM-J7700
Normal Font A (6 lpi) (lps) 24.8 23.8 23.2 22.8 19.8 16.9
Font B (8 lpi) (lps) 33.1 31.7 30.9 30.4 26.4 22.6
Graphics (mm/s) 107 102 100 98 85 73
High-speed Font A (6 lpi) (lps) 24.8 23.8 23.2 22.8 19.8 16.9
Font B (8 lpi) (lps) 33.1 31.7 30.9 30.4 26.4 22.6
Graphics (mm/s) 107 102 100 98 85 73
Economy Font A (6 lpi) (lps) 24.8 23.8 23.2 22.8 19.8 16.9
Font B (8 lpi) (lps) 33.1 31.7 30.9 30.4 26.4 22.6
Graphics (mm/s) 107 102 100 98 85 73
 Print speed when continuously printing for all lines without cleaning and without character
styles.
 The print speed may decrease due to the transmission status or the combination of commands.
 If the line spacing of the print data is smaller than the font height, the print speed may decrease
due to printing one line at a time.