Epson TM-L100

89
Chapter 4 Advanced Usage
Serial Interface Settings (Serial model only)
Baud rate
• 115200 bps (initial setting)
• 2400 bps
• 4800 bps
• 9600 bps
• 19200 bps
• 38400 bps
• 57600 bps
Parity
• None (initial setting)
• Odd parity
• Even parity
Handshake
• DTR/DSR control (initial setting)
• XON/XOFF control
Bit length
• 8-bit wide (initial setting)
• 7-bit wide
Receipt Enhancement
Functions Available settings Initial setting
Automatic top logo printing Key code Undefined
Justification (Left justified, Centered, Right justified) Undefined
Number of deleted lines after top logo printing Undefined
Automatic bottom logo printing Key code Undefined
Justification (Left justified, Centered, Right justified) Undefined
Advanced settings for automatic top/
bottom logo printing
Print top logo when paper is fed to the cut position
(Enabled/Disabled)
Enabled
Print top logo at power-on (Enabled/Disabled) Disabled
Print top logo when the roll paper cover is closed (Enabled/
Disabled)
Enabled
Print top logo when the buffer is cleared during a recover-
able error.(Enabled/Disabled)
Enabled
Print top logo when advancing paper using the Feed but-
ton is finished (Enabled/Disabled)
Disabled