3-18 Disassembly and Assembly Rev.C
Confidential
5. Remove the two E-rings (E2).
6. Remove the two cover rotation shafts by pressing them inside.
7. Remove the roll paper cover unit. Then, pull the lead wire of the BM paper detector circuit
board assembly out through the clearance in the hinge cover.
To remove the roll paper cover unit, position the cover unit as shown below and pull out the
unit in the direction shown with the arrow in the illustration.
Note:
When you need to disassemble or assemble the roll paper cover unit further, see page 3-35 for instructions.
Install in the reverse sequence of removal.
Roll paper cover unit
E2
Cover rotation shafts
E2
Hinge cover
Roll paper cover unit
To Next Page
Loading...
