3-34 Disassembly and Assembly Rev.C
Confidential
Paper Feed Motor
1. Remove two W1 washers and one motor ground plate by removing three N1 nuts.
2. Slide out the paper feed motor from the hole in the frame L assembly.
3. Remove the three paper feed motor dampers from the paper feed motor.
4. Remove the three spacers from inside the three paper feed motor dampers.
Install using the following steps:
1. Insert the three spacers into the three paper feed motor dampers.
2. Insert the motor dampers into the three holes in the frame L assembly.
3. Install the paper feed motor. To do this, insert the motor shaft into the cutout in the frame L
assembly; then insert the three screws on the motor into the holes in the three paper feed
motor dampers.
4. Install two W1 washers and one motor ground plate. Then, make sure the ground plate
touches the frame L assembly. If you insert the ground plate in an incorrect way, it does not
touch the frame.
5. Tighten the three N1 nuts with the specified torque of 34.3 to 39.2 Ncm (3.5 to 4.0 kgcm) in
the order shown in the illustration above. Make sure the motor ground plate is attached at
the angle shown in the illustration above.
CAUTION:
Tighten the three nuts with the specified torque. If you overtighten these nuts, the
screws on the paper feed motor become loose when you loosen the nuts the next
time.
Paper feed motor
N1
Paper feed motor damper
Frame L assembly
Motor ground plate
Paper feed motor damper
Spacer
Spacer
Paper feed motor
Spacer
W1
N1
W1
N1
damper
To Next Page
Loading...
