Epson TM T70 Technical Reference Guide

32
Setting the DIP Switches
On this printer, you can make various settings with DIP switches.
Setting Procedure
Follow the steps below to change the DIP switch settings.
1
Make sure the power supply for the printer is turned off.
2
Unscrew the screw to remove the DIP switch cover from the base of the
printer.
3
Set the DIP switches, using the tip of a tool, such as a small screwdriver.
4
Attach the DIP switch cover, and screw it in place.
For models with the buzzer function, see also "Setting the Buzzer" on page 49.
CAUTION
Before you remove the DIP switch cover, turn the printer off.
Otherwise, a short-circuit may cause the printer to malfunction.
DIP switch settings are enabled only when the power is turned on or the printer is reset via
the interface. If the settings are changed after that, the functions will not change.
DSW1
DSW2
DIP switch 2
DIP switch 1

Epson TM T70 Specifications

General

Resolution	180 dpi
Auto Cutter	Yes
Print Method	Thermal line
Paper Width	79.5 ±0.5 mm
Interface	USB, Ethernet
Power Supply	AC adapter