3-2 Command Reference Rev. A
Function Type
Function Type Command Name Matrix Category
Supported Command
T88 T88M T85
Print
commands
LF
Print and line feed Basic single
●●●
FF
1. Print and eject cut sheet (in
standard mode)
Mechanical extension
2. Print and return to standard
mode (in page mode)
Mechanical extension
●●●
3. Print and feed label to print
starting position (on label)
Mechanical extension
CR
Print and carriage return Mechanical extension
OOO
ESC FF
Print data in page mode Software extension
●●●
ESC J
Print and feed paper Mechanical extension
●●●
ESC K
Print and reverse feed Mechanical extension
ESC d
Print and feed n lines Basic single
●●●
ESC e
Print and reverse feed n lines Mechanical extension
GS FF
Print and eject label Hardware extension
Line spacing
commands
ESC 2
Select default line spacing Mechanical extension
●●●
ESC 3
Set line spacing Mechanical extension
●●●
ESC C
Set cut sheet eject length Mechanical extension
Character
commands
CAN
Cancel print data in page mode Software extension
●●●
ESC SP
Set right-side character spacing Basic single
●●●
ESC !
Select print mode(s) Basic single
●●●
ESC %
Select/cancel user-defined
character set
Software extension
●●●
ESC &
Define user-defined characters Software extension
●●●
ESC –
Turn underline mode on/off Software extension
●●●
ESC ?
Cancel user-defined characters Software extension
●●●
ESC E
Turn emphasized mode on/off Software extension
●●●
ESC G
Turn double-strike mode on/off Software extension
●●●
ESC R
Select an international character
set
Basic single
●●●
ESC V
Turn 90° clockwise rotation mode
on/off
Software extension
●●●
ESC r
Select print color Mechanical extension
ESC t
Select character code table Basic single
●●●
The TM-T88/T88P/T88M/T88PM/T85/T85P supports the commands marked with a
●
in the “Supported Command” column.
The TM-T88P/T88PM/T85P supports the commands marked with a O in the “Supported Command” column.
To Next Page
Loading...
Need help?
General
