Epson TM-T88 - Print Density Selection

Rev. A Command Reference 3-3
TM–T88/T88P (TM–T85/T85P) Information Manual
Character
commands
(continued)
ESC z Turn parallel printing mode on/off
for receipt and journal paper
Mechanical extension
ESC { Turn upside-down printing mode
on/off
Basic single
●●●
GS ! Select character size Software extension ●●●
GS B Turn white/black reverse printing
mode on/off
Software extension ●●●
GS b Turn smoothing mode on/off Software extension ●●●
Paper sensor
commands
ESC c 3 Select paper sensor(s) to output
paper-end signals
Mechanical extension
OOO
ESC c 4 Select paper sensor(s) to stop
printing
Mechanical extension ●●●
Panel button
commands
ESC c 5 Enable/disable panel buttons Hardware extension
●●●
ESC c 6 Enable/disable on-line switch Hardware extension
Printing
paper
commands
ESC c 0 Select paper type(s) for printing Basic multiple
ESC c 1 Select paper type(s) for command
settings
Mechanical extension
ESC f Set cut sheet wait time Mechanical extension
Print position
commands
HT Horizontal tab Software extension
●●●
RS Journal tab Mechanical extension
ESC $ Set absolute print position Software extension
●●●
ESC D Set horizontal tab positions Software extension ●●●
ESC T Select print direction in page mode Software extension ●●●
ESC W Set printing area in page mode Software extension ●●●
ESC \ Set relative print position Software extension ●●●
ESC a Select justification Software extension ●●●
GS $ Set absolute vertical print position in
page mode
Software extension ●●●
GS L Set left margin Software extension ●●●
GS W Set printing area width Software extension ●●●
GS \ Set relative vertical print position in
page mode
Software extension ●●●
Function Type Command Name Matrix Category
Supported Command
T88 T88M T85
The TM-T88/T88P/T88M/T88PM/T85/T85P supports the commands marked with a
●
in the “Supported Command” column.
The TM-T88P/T88PM/T85P supports the commands marked with a O in the “Supported Command” column.