Related Information
& “Soware Update Tools (EPSON Soware Updater)” on page 105
& “Uninstalling Applications” on page 107
Updating the Printer's Firmware Using the Control
Panel
If the printer is connected to the Internet, you can update the printer's rmware using the control panel. You can
also set the printer to regularly check for rmware updates and notify you if any are available.
1. Select Settings on the home screen.
2. Select System Administration > Firmware Update > Update.
Note:
Enable Notication to set the printer to regularly check for available rmware updates.
3. Check the message displayed on the screen, and then press the OK button to start searching for available
updates.
e printer starts searching for available updates.
4. If a message is displayed on the screen informing you that a rmware update is available, follow the on-screen
instructions to start the update.
c
Important:
❏ Do not turn o or unplug the printer until the update is complete; otherwise, the printer may malfunction.
❏ If the rmware update is not completed or is unsuccessful, the printer does not start up normally and
"Recovery Mode" is displayed on the LCD screen the next time the printer is turned on. In this situation, you
need to update the rmware again using a computer. Connect the printer to the computer with a USB cable.
While "Recovery Mode" is displayed on the printer, you cannot update the rmware over a network
connection. On the computer, access your local Epson website, and then download the latest printer
rmware. See the instructions on the website for the next steps.
Uninstalling Applications
Log in to your computer as an administrator. Enter the administrator password if the computer prompts you.
Uninstalling Applications - Windows
1. Press the
P
button to turn o the printer.
2. Quit all running applications.
User's Guide
Network Service and Software Information
107
To Next Page
Loading...
Need help?
General
