❏ TCP/IP Address
❏ Auto
Select when you are using an access point at home or you are allowing the IP address to be acquired
automatically by DHCP.
❏ Manual
Select when you do not want the printer's IP address to be changed. Enter the addresses for IP Address,
Subnet Mask, and Default Gateway, and make DNS Server settings according to your network environment.
❏ DNS Server
❏ Auto
Select when you want to acquire the IP address automatically.
❏ Manual
Select when you want to set a unique DNS server address to the printer. Enter the addresses for the Primary
DNS Server and the Seconday DNS Server.
❏ Proxy Server
❏ Do Not Use
Select when you are using the printer in a home network environment.
❏ Use
Select when you are using a proxy server in your network environment and you want to set it to the printer.
Enter the proxy server address and port number.
❏ IPv6 Address
❏ Enable
Select this when using an IPv6 address.
❏ Disable
Select this when using an IPv4 address.
❏ NFC
❏ Enable
Enables the printer's NFC function. You can print by touching the smart device to theN-Mark.
❏ Disable
Disables the printer's NFC function.
❏ Link Speed & Duplex
Select an appropriate Ethernet speed and duplex setting. If you select a setting other than Auto, make sure the
setting corresponds to the settings on the hub you are using.
❏ Auto
❏ 10BASE-T Half Duplex
❏ 10BASE-T Full Duplex
❏ 100BASE-TX Half Duplex
❏ 100BASE-TX Full Duplex
User's Guide
Network Settings
24
To Next Page
Loading...
Need help?
General
