-14-
05/2021HB60
Danger: in the work area only one single operator can be present at one time.
Danger: during the bending phases, the operator must always be in a position opposite the
movement direction during bending. Operator must always be in position to press emergency
stop button.
3.2. Environmental parameters
The HB60 machine was designed to resist corrosion. All of its components, excluding moving ones, are
covered with oven-baked epoxy paint. However, the machine has been designed to be used indoors and
in environments away from the sea coast: contact the Customer Service of the Manufacturer for installa-
tions other than those mentioned above. The recommended environmental conditions are: Temperature:
5°C - 30°C. with Humidity: 40% - 75%. If the temperature of the installation area differs from the indicated
range, the recommended hydraulic oil may no longer be suitable to guarantee machine performance: con-
tact the manufacturer’s customer service for advice.
3.3. Connecting to the mains
Danger: HB60 machine must be powered with alternating current (AC) at the indicated
frequency and voltage.
Attention: manufacturer is not liable for faults caused by an incorrect electrical
connection implemented by the user.
Attention: Connection to power mains must be made by qualied personnel.
Danger: Electrical panel must be opened by qualied personnel Opening and
tampering with electrical components can jeopardize operator safety and
correct machine operation.
Attention: Make sure power phasing is correct.
Danger: Switch main power to o and disconnect from power source before accessing
electrical compartment of machine make sure that it is switched.
To Next Page
Loading...