Cleaning and maintenance
48/76
When assembling the device please note:
– Refit and retighten the screws.
7.11 Cleaning or replacing UV lamps and
filter panels in the canopy
– Removing the canopy panel: see page 40.
– Remove the screws and then remove the lamp cover.
The following components listed in the maintenance plan are fitted in the
canopy:
UV low pressure lamps: see page 44.
Facial tanner UV high pressure lamps and filter panels: see page 45.
Facial tanner filter panels
Facial tanner UV low pressure lamps and the associated starters
Changing the chip card: see page 43.
The facial tanner's UV low pressure lamps must be removed first so that the
UV high pressure lamps and the filter panels can be changed.
– Remove the lamps.
To Next Page
Loading...
