Operation
26/76
6.5.2 SUN SELECT
SUNSELECT allows you to preselect your skin type and your preferred tan-
ning level. The SUNSELECT control panel is part of the Control center (see
page 22).
A Voice Guide will assist you during operation.
NOTE:
Without selection the unit will automatically start with the
lowest tanning level and skin type fair.
The default setting after each tanning session is also tanning
level 1 and skin type fair.
NOTE:
The SUNSELECT setting can be changed within
two minutes after starting the tanning session.
The SUNSELECT settings adjust the exposure rate and not the tanning time.
The tanning time is set as usual and must correspond to the times given in
the exposure label, see page 6.
The unit emits the maximum exposure with the setting skin type brown and
tanning level 3. The distinction between the settings is very subtle.
To Next Page
Loading...
