6. Step
As soon as the countdown is finished and
the signal has sounded you have to pull
the rocker lever towards the handle.
7. Step
Now slew the sealing head to the left
while keeping the rocker lever pulled..
Fig. 76
Fig. 75
-52-
The welding process is finished, once the
indicator bar (1) is filled fully.
The cool down starts (2). After cool down there
is a beep and the display lights up green.
The tensioning process is finished, once the
indicator bar is filled in fully.
Fig. 74
Fig. 73
Attention!
If after pressing the welding button, the
welding process does not start, but the
sealing head beeps, the tension button
was not pressed first.
Attention!
It is recommended to clean the sealing
head regularly (at least daily), if there is a
lot of strap waste. Especially the tension
wheel and the tooth plate have to be
checked for damages and kept clean.
Please refer to section 10.10.
To Next Page
Loading...
