10.3 Replacing the reversing sledge
-66-
…until approx. 60 cm of the chain
stands in an upward position.
Then, switch off the strapping
system by pressing the OFF button
and disconnect the power cable
from the battery pack.
2. Step
Set the pallet width at the
display of the strapping system
to 1m and drive out the
ChainLance…
1. Step
Cut off the strap in front of the white
roll and fix it with an adhesive strip to
the coil. Pull out the rest of the strap
remained in the strapping system
through the head piece of the
ChainLance and dispose it.
Fig. 99
Fig. 100
Fig. 101
To Next Page
Loading...
