Warning!
Following hazards can result in serious injuries:
Breaking strap, risk of injury
When being tensioned, the strap may break and rip. Do not stand
in line with the strap and wear eye protection.
Strap ends snapping back, risk of injury
When cutting the strap, hold the upper portion and stand aside.
Do not stand in line with the strap and wear eye protection.
ChainLance, risk of tripping
When parking the strapping system, the ChainLance must be fully
inside it. The reversing sledge must not stick out.
Strap waste, risk of tripping
Make sure any strap waste or pieces of strap, which possibly
appeared, will be removed from the floor quickly.
Sealing head and ChainLance, risk of crushing
Do not put your fingers into the area of the tension wheel of the
sealing head and into the ChainLance.
Reversing sledge, risk of crushing
Especially around the entire surroundings of the reversing sledge,
there is a risk of squeezing.
Hazardous area, risk of crushing and risk of injury
Make sure before each strapping cycle, that there is no person in
the hazardous area (especially of the ChainLance) and nobody can
enter that area. This is due, especially for the limited or bad visible
area on the opposite site of the pallet (operators view). During
strapping, there must not be any hands or other body parts
between strap and goods.
Power source, risk of injury
Before maintenance or repair works:
Switch off the strapping system by pressing the „OFF“ switch,
remove the key from the main switch and unplug the main power
cable from the battery.
-58-
To Next Page
Loading...
