Ericsson RX1290 - Factory Default Settings for Outputs, Alarms, and System; Defaults for Output and Alarm Menus; Defaults for System Setup Menu

Factory Defaults
Menu Description Default
ASYNC DATA ENABLED
SYNC DATA (High Speed Ethernet
Data Not Fitted)
ENABLED
ETH.NET DATA (High Speed Ethernet
Data Fitted)
ENABLED
VITC INSERTION ENABLED
CLOSED CAPTION ENABLED
PCR PID
TS OUTPUT POST INPUT
CONNECTOR 1 DISABLED
CONNECTOR 2 DISABLED
#5 Output
CONNECTOR 3 DISABLED
IF NO TRANSPORT STREAM NO ALARM
IF VIDEO NOT RUNNING NO ALARM
IF AUDIO 1 NOT RUNNING NO ALARM
IF AUDIO 2 NOT RUNNING NO ALARM
IF AUDIO 3 NOT RUNNING NO ALARM
IF AUDIO 4 NOT RUNNING NO ALARM
IF MER LESS THAN 0.00 NO ALARM
IF BER EXCEEDS 1.0 E-8 NO ALARM
IF EBNO EXCEEDS……. NO ALARM
#6 Alarm
IF TEMPERATURE EXCEEDS 65 NO ALARM
OPERATING MODE FRONT PANEL
LCD CONTRAST MEDIUM
SERIAL REMOTE CONTROL RS-232 TTV
IP ADDRESS 155.155.155.201
SUBNET MASK 255.255.255.000
GATEWAY ADDRESS 155.155.155.001
SYSLOG IP ADDRESS NOT SET
SERVICE HUNT MODE ENABLED
SI MODE AUTO
#7 Setup
CUSTOMIZATION KEY UNAFFECTED
EN/LZT 790 0003/2 R1A
E-3