Ericsson RX1290 - Ancillary Data Settings; Teletext and VITC Setup

Operating the Equipment Locally
Step Action Result
2
Scroll to Menu 3.8.1 and edit
the High speed data output
(ENABLED or DISABLED).
Press Save.
The unit receives and displays the correct bit-
rate.
3
Scroll to Menu 3.8.3 and edit
the Forward to Gateway
ON/OFF and the Gateway IP
address menu. Press Save.
If the Forward to Gateway option is turned on,
the unit will forward the data stream to the
gateway address given.
3.7.11 Setting Up Teletext
Table 3.20 Setting Up Teletext
Step Action Result
1
Scroll to Menu 3.9. and edit
the parameter for stream or
PID value. Press Save.
Edits the parameter for choosing the appropriate
component or PID if the required Teletext data
is not currently present
2
Scroll to menu 3.9.1 and edit
the parameter for enabling
Teletext (ENABLED or
DISABLED)
Enables/Disables Teletext
3
Scroll to menu 3.9.2 and edit
the parameter (ENABLED or
DISABLED)
Chooses if the Teletext is played out straight
away or on the PTS
3.7.12 Setting Up VITC
Table 3.21 Setting Up VITC
Step Action Result
1
Scroll to Menu 3.10.1 and edit
the parameter for enabling
VITC pass-through (ENABLED
or DISABLED). Press Save.
Edits the parameter for enabling VITC
pass-through.
2
Scroll to menu 3.10.2 and edit
the line number for VITC to be
inserted
Selects the line for VITC insertion.
EN/LZT 790 0003/2 R1A
3-19