Ericsson RX1290 - Service and Conditional Access Settings; DVB Subtitles and PID;Network ID Menus; Conditional Access;Scrambling Setup (Menu 4)

Operating the Equipment Locally
3.7.25 Setting Up DVB Subtitles
Table 3.34 Setting Up DVB Subtitles
Step Action Result
1
Scroll down to Menu 3.15.1
and edit the parameter for
enabling DVB Subtitles
(ENABLED or DISABLED).
Press Save.
Edits the parameter for enabling DVB Subtitles.
PLEASE NOTE: This feature is only supported
for SD 4:2:0 video sources only.
3.7.26 Setting the PCR PID Menu
Table 3.35 Viewing the PCR PID Menu
Step Action Result
1
Go to Menu 3.16 and scroll to
USER PID and edit the PID for
enabling manual selection of
the PCR PID.
Gains access to the selection between
automatically detected PCR PID or manually
entered PCR PID.
3.7.27 Viewing the Network ID Menu
Table 3.36 Viewing the Network ID Menu
Step Action Result
1 Go to Menu 3.17.
Gains access to the Network ID and the Original
Network ID.
3.8 Setting Up the Conditional Access/Scrambling (Menu 4)
3.8.1 Introduction
Menu 4 allows the status and configuration of the Conditional Access (CA) module
to be checked. The structure and content of this group depends on the CA system.
The available CA options are as follows:
• Basic Interoperable Scrambling System (BISS), Mode 1 and Mode E only.
• Remote Authorisation System (RAS) and RAS 2
• Director
• DVB Common Interface
BISS (as specified in EBU Tech 3292 May 2002) is standard on all units.
EN/LZT 790 0003/2 R1A
3-23