Ericsson RX1290 - DVB-S2 Input Card Connector Details; IF Monitor Input Connector Details; Constellation Output Connectors

Options
Table 6.1 DVB-S2 Satellite Receiver (L-band) Connector
Input Specification
Connector Type F-type, Female
Connector designation
IN 1, IN 2, IN 3, IN 4
3 x L-band inputs only on RX1290/HWO/DVBS2/IF/CONST
Pin: Centre
Shield
RF Input
Ground/Chassis
LNB Supply Refer to the next caution box
Impedance
75 Ω
Cautions!
The receiver provides DC power (refer to Chapter 3, Operating the Equipment
Locally) via the active L-band input connector to drive an LNB (Low Noise Block
Down-Converter). Do not connect equipment other than an LNB to this connector.
Failure to do this may result in damage to the external equipment.
The F-type Connector is not suitable for repeated connection and disconnection.
When intended for use in this way, fit a sacrificial connector and connect to it.
6.2.3 Connector Details – IF Monitor Input (RX1290/HWO/DVBS2/IF/CONST)
Connect the IF Monitor input to a suitable IF frequency source e.g. a
satellite modulator. The input can be activated using Input Status
Menu (Menu 2).
This monitor input is designed to give error-free demodulation in the
presence of a wanted carrier only, for example when being fed
directly from a satellite modulator.
The specification for this connector is given in Annex B, Technical Specification.
Table 6.2 DVB-S2 Satellite Receiver (IF Monitor Input) Connector
IF In
p
ut
Input Specification
Connector Type BNC, Female
Connector designation IF
Pin: Centre
Shield
IF Input
Ground/Chassis
Impedance
75 Ω
EN/LZT 790 0003/2 R1A
6-4