Ericsson RX1290 - Chapter 4: Operating the Equipment Remotely; Remote Control Overview; Remote Protocol Documentation; Remote Control Configuration Methods

4 Operating the Equipment Remotely
Chapter 4
Contents
4.1 Remote Control ....................................................................................4-3
4.1.1 Introduction...........................................................................................4-3
4.1.2 Remote Protocol Control Documentation ............................................. 4-3
4.1.3 Configuring the Unit for Remote Control via SNMP Port......................4-3
4.1.4 Configuring the Unit for Remote Control Via the Serial Remote Port...4-3
4.1.5 Configuring the Unit for Remote Control Over-air ................................4-4
4.1.5.1 Overview............................................................................................... 4-4
4.1.5.2 OAC Lockout ........................................................................................4-4
4.1.5.3 Entering the OAC Lockout PIN............................................................. 4-5
4.2 Returning the Unit to Local Control Mode ............................................4-5
List of Tables
Table 4.1
Configuring the Serial Remote Port and Activating Remote Protocol
(SNMP)................................................................................................. 4-3
Table 4.2 Configuring the Serial Remote Port and Activating Remote Protocol ..4-4
Table 4.3 Activating Director NCP Remote Control.............................................. 4-4
Table 4.4 Entering the OAC Lockout PIN............................................................. 4-5
Table 4.5 Configuring the Unit for Local Control ..................................................4-5
EN/LZT 790 0003/2 R1A
4-1