ero electronic LDE - Page 64

B. 2
DEFAULT CONFIGURATION
PARAMETERS
The configuration parameters can be loaded with
predetermined default values. These data are the
typical values loaded in the instrument prior to
shipment from factory. To load the default values
proceed as follows:
a) In "normal display mode", press SMT and
FUNC pushbutton for more than 3 secs.
LME LDE (alternatively):
b) Push the t or s pushbutton; display will
show:
c) Press FUNC to confirm.
d) Press the t pushbutton; display will show
the firmware version.
e) Mantaining the pressure on the t
pushbutton, push the s pushbutton too.
The instrument will show:
f) Press s pushbutton to select between table
1 (european) or table 2 (american) default
parameter set. The display will show:
g) Press FUNC pushbutton; the display will
show:
This means that the loading procedure starts.
After about 3 seconds the loading procedure is
terminated.
OFFOFF
OFFOFF
OFF
CnFCnF
CnFCnF
CnF
ONON
ONON
ON
CnFCnF
CnFCnF
CnF
dl.fdl.f
dl.fdl.f
dl.f
CnFCnF
CnFCnF
CnF
ONON
ONON
ON
dL.1dL.1
dL.1dL.1
dL.1
L.dtL.dt
L.dtL.dt
L.dt
OfOf
OfOf
Of
ff
ff
f
CnfCnf
CnfCnf
Cnf
CnfCnf
CnfCnf
Cnf
CnfCnf
CnfCnf
Cnf
A.01A.01
A.01A.01
A.01
A.01A.01
A.01A.01
A.01
lxe-a-B00.p65 10/18/02, 3:45 PM2