ESAB ES 95i - Page 5

EU DECLARATION OF CONFORMITY
According to
The Low Voltage Directive 2014/35/EU, entering into force 20 April 2016
The EMC Directive 2014/30/EU, entering into force 20 April 2016
The RoHS Directive 2011/65/EU, entering into force 2 January 2013
Type of equipment
WELDING POWER SUPPLY
Type designation etc.
ESAB ES 95i
Brand name or trade mark
ESAB
Manufacturer or his authorised representative established within the EEA
Name, address, telephone No:
ESAB Group Inc.
2800 Airport Rd
Denton TX 76207
Phone: +01 800 426 1888, FAX +01 603 298 7402
The following harmonised standard in force within the EEA has been used in the design:
EN 60974-1:2012 Arc Welding Equipment - Part 1: Welding power sources.
EN 60974-10:2007 Arc Welding Equipment - Part 10: Electromagnetic compatibility (EMC) requirements
Additional Information: Restrictive use, Class A equipment, intended for use in location other than residential.
By signing this document, the undersigned declares as manufacturer, or the manufacturer’s authorised
representative established within the EEA, that the equipment in question complies with the safety re-
quirements stated above.
Date Signature Position
1 November 2015 Vice President,
Antonio Leon Brand Management
Manual Cutting Equipment
2016