ESAB PEH4.0 User Manual

-- 9 --
fzb2d1ea
PEH in C&B
From 99.04.01
PEH program (Flash, IC 15) 486471880
PEH 2.3
DCDUO program (Prom, IC304) 68S07001A02
CHKSUM 0221
Dat. 1998.04.04
PEH program for use in stations with a Roller bed/ Positioner (Analogue Motor node) and an
RCC--unit (Digital I/O node).
Note! This program version cannot handle a Roller bed/positioner without an RCC--unit.
Contact ESAB for custom--made program.
From 99.01.15
Digital I/O -- node 486592880
DIGIO1.0
From 99.06.01
Digital I/O -- node 486592882
DIGIO1.1
Safer readings of push buttons preventing unrequested stop during welding.
From 02.11.15
Digital I/O -- node 486592882
DIGIO4.0
Safer bus communication with PEH.
Programversion PEH4.0 or PEH4.0C is needed.
From 99.01.15
Analogue Motor node 486569880
RB 1.1
From 99.06.20
Analogue Motor node 486569880
RB 1.2
Roller bed / Positioner can be controlled from PEH (using SHIFT + 9), RCC unit not necessary.
For PEH program, contact ESAB for custom--made program.
From 02.11.15
Analogue Motor node 486569880
RB 4.0
Returns actual speed for external travel axis.
Programversion PEH4.0 or PEH4.0C is needed.
GB

ESAB PEH4.0 Specifications

General

Brand	ESAB
Model	PEH4.0
Category	Controller
Language	English