ESAB PEH4.0 User Manual

-- 2 --
TOCe
1 READ THIS FIRST 4..................................................
1.1 General 4..................................................................
1.2 Software versions 5.........................................................
2SAFETY 11...........................................................
3 COMPONENT DESCRIPTION 13.......................................
4 CONNECTION DIAGRAM 14...........................................
5 COMPONENT POSITIONS ON CIRCUIT BOARD AP2 16..................
6 COMPONENT POSITIONS ON CIRCUIT BOARD AP1 17..................
7 FUNCTION DESCRIPTION (CIRCUIT BOARD) 18........................
7.1 General 18..................................................................
7.2 NME (AP2) 18..............................................................
7.3 DC DUO (AP1) 19...........................................................
8 TEST POINTS 20......................................................
8.1 Testing the external power supply (from the welding power source) 20...............
8.2 Testing the internal power supply voltages 20....................................
8.3 Checking that the program is running 21.........................................
8.4 Checking NO. 1 output stage 21................................................
8.5 Checking NO. 2 output stage 21................................................
8.6 Gas valve output control 21....................................................
8.7 Measuring the motor current 21................................................
9 INSTALLATION 22....................................................
9.1 General 22..................................................................
9.2 Internal connections 22.......................................................
9.3 External connections 23.......................................................
9.4 Adjusting the DC DUO 25.....................................................
9.5 NME connection 25...........................................................
9.6 Connection between the DC DUO and the NME 26...............................
10 USING THE CONTROL PANEL 27......................................
10.1 Control panel 27.............................................................
10.2 Using the keys 28............................................................
11 PRESET SYSTEM MENU 29............................................
11.1 General 29..................................................................
11.2 System function settings available 29...........................................
12 DEFINITIONS (PRESET SYSTEM MENU) 30.............................
12.1 Product code 30.............................................................
12.2 Weld process 41.............................................................
12.3 POWER SOURCE MENU 42..................................................
12.4 Gas preflow (s) (only for GMAW) 47............................................
12.5 Gas postflow (s) (only for GMAW) 47...........................................
12.6 Password 48................................................................
12.7 Cable length (m) 49..........................................................
12.8 Cable area (mm2) 49.........................................................
12.9 Weldhead offset, mm 50......................................................
12.10 START SEQUENCE MENU 51.................................................
12.11 STOP SEQUENCE MENU 53..................................................
12.12 CALIBRATION MENU 55......................................................
12.13 DISPLAY MENU 57..........................................................
12.14 ERROR LIST 59.............................................................
12.15 Test 61.....................................................................
13 PRESET SYSTEM MENU OVER VIEW 62................................
14 CHANGE OF PROGRAM 63............................................
14.1 General 63..................................................................
14.2 Storing trimming data 63......................................................
14.3 Changing the program in the PEH electronics: 64.................................
14.4 Changing programs in the PEH electronics and the welding power source: 64........

ESAB PEH4.0 Specifications

General

Brand	ESAB
Model	PEH4.0
Category	Controller
Language	English