-- 5 3 --
fzb2d3ea
12.11 STOP SEQUENCE MENU
Cablearea(mm2) X
Weldhead offset, mm
START SEQUENCE MENU
STOP SEQUENCE MENU
CALIBRATION MENU
DISPLAY MENU
ERROR LIST
Test 0/1/2
The following menu is shown when STOP SEQUENCE MENU has been selected:
STOP PHASE 1
STOP PHASE 2
The stop sequence menu is mainly used for programming the crater filling. It
is programmed in the same way as the start sequence menu.
In the stop sequence m enu a phase can be interrupted by pressing the stop key .
PHASE2 has no effect if t=0in PHASE1.
t = the durability of the sequence, indicated in intervals of 0.1 s (m ax. 99.9 s).
N.B. PHASE2 is not available in the Chinese version.
GB
To Next Page
Loading...