-- 2 9 --
fzb2d3ea
11 PRESET SYSTEM MENU
11.1 General
The PRESET SYSTEM MENU is used to configure the equipment connected to
the A2--A6 Process Controller (PEH) to give the correct performance of the
complete system.
The control unit variables are set to their optimum settings before the equipment is
delivered from ESAB, and should not normally need to be changed when the
equipment has been supplied to the customer.
If changing any of the variables, use the product codes for ESAB’s A2--A6 automatic
welding machines or for other systems that can be directly connected to the control
system.
The product code includes information on gear ratios, motor types, drive rollers,
diameters etc.
For information about the Control panel and information about how to use the keys,
see pages 27 --28.
11.2 System function settings available
PRESET SYSTEM MENU
A B
12:1 Product code (see page 30) A2TFE / A2TGE / A2TFH / A2TGH /
A6TFE / A6TGE / FREE2AX / FREE3AX
12:2 Weld process (see page 41) SA W / GMAW / ESW / Gauging
12:3
POWER SOURCE MENU (see page 42)
X
12:4 Gas preflow (s) (see page 47) 1-- 99
12:5 Gas postflow (s) (see page 47) 1-- 99
12:6 Password (see page 48) XXXXX
12:7 Cable length (m) (see page 49) X
12:8 Cable area (mm2) (see page 49) X
12:9 Weldhead offset, mm (see page 50) X
12:10 START SEQUENCE MENU (see page 51)
12:11 STOP SEQUENCE MENU (see page 53)
12:12 CALIBRATION MENU (see page 55)
12:13 DISPLAY MENU (see page 57)
12:14 ERROR LIST (see page 59)
12:15 Test (see page 61) 0/1/2
GB
To Next Page