--1) Choose “System setting” > “Advanced setting”；
--2) Enter the password required（The default is empty) ；
--3) Choose “SIP” > “Account sip”；
--4) Choose one of the account you want to setting, you can
configure the following parameters
-Enable account*: choose Enable
-Display Name: The name displayed on the screen
-User Name*: the account matched with the SIP server.
（extension number) ,
-Authen usr: the Authenticated users matched with the SIP
server.（The default With the same account)
-user pwd*: the user password matched with the SIP server
-Description: description of this account,
-SIP1*: the primary SIP server, By default all calls through
the server,
-SIP2: the secondary SIP , When the primary server is
unavailable ,use the SIP server
-Refresh time: Registration refresh interval, the minimum
value is 20 The default value is 3600.
--5) Set up the above parameters, Press softkey to saves
settings, Complete the account creation；
* Note: the parameters with the * mark must be set.
--1) Choose “System setting” > “Advanced setting”；
--2) Enter the password required（The default is empty) ；
--3) Choose “SIP” > “Account sip”；
--4) Choose “Enable account” > “Disable”；
--5) Press soft key
To Next Page
Loading...
