--1) Choose “System setting” > “Advanced setting”；
--2) Enter the password required（The default is empty) ；
--3) Choose “Network”, you can configure the following parameters:
-Type: static IP or DHCP
-IP: enter IP address , Note: Do not duplicate the IP address
with other devices on the network
-Mask: enter appropriate subnet mask
-GW: enter appropriate gateway
- DNS1: enter IP address of the primary DNS server
- DNS2: enter IP address of the secondary DNS server
-Web port: the default Web port is 80,if you change it(for
example change it to 88),you must use IP and Web port to login
the web page (for example http://192.168.0.200:88).It will take
effect on next reboot.
-Telnet port: the default Telnet port is 23,if you change it(for
example change it to 2003),you must use IP and Telnet port to
login the manage page (for example telnet 192.168.0.200:2003).It
will take effect on next reboot.
To Next Page
Loading...
