Appendix：
Auto Provision
Pre-configuration on TFTP/HTTP/HTTPS/FTP Server
When the software or kernel auto-provision is enabled and want to run, IP
Phone will check the software and kernel version at first, so we need make
some pre-configuration on the provisioning server.
Auto Provision for Software:
1. Create a notepad file named“F000X00.cfg”(the “X” is decided by the
model of the IP phone you are using, for example, if the model is ES620,
the file name is “F000600.cfg”);
*Named rule of the file:
F00600.cfg: for ES620, ES610 and DS622;
F00400.cfg: for ES410 and DS412;
F00300.cfg: for ES310 and DS312;
F00200.cfg: for ES210 and DS212.
2. Open the notepad file “F000X00.cfg” and write the new software name in it,
for example,
S_ES6xx_version2.0.4.6: for ES620, ES610 and DS622;
S_ES410_version2.0.4.6: for ES410 and DS412;
S_ES310_version2.0.4.6: for ES310 and DS312;
S_ES210_version2.0.4.6: for ES210 and DS212
Write down the new version you want to upgrade and save it on your
provisioning server.
*Please note that if the version is not older than (and same as) the one on your
phone, auto-provision of your software would be not available.
3. After it, upload the new software to the TFTP/HTTP/HTTPS/FTP
provisioning server and complete the pre-configuration steps.
Auto Provision for Kernel:
1. Create a notepad file named“K000X00.cfg”(the “X” is decided by the
To Next Page
Loading...
