ESI IVX 20 - User Programming

Digital Feature Phone operation IVX 20
A.24
User programming
All user-controlled features can be programmed from your station by following the voice-prompted
menus to:
• Set or change the programmable feature keys (see "Programmable feature keys,” page A.26)
• Enable/disable station options (see "Station options,” page A.28)
• Set station ring tone or ring volume
• Set or record voice mail options
• Set paging number
• Recover messages deleted in error
Enter programming mode by pressing the PROG/HELP Key (your station will be placed in DND mode
until you exit).
Voice prompts will play menu and sub-menu options to access the desired feature. You don't have
to wait for the entire prompt to be played. Therefore, once you’ve become familiar with the prompts
(consult "User programming menu overview,” next page), you can quickly set any frequently used
feature.
Example: Press PROG/HELP 3 3 1 to enter programming and then turn on headset mode
(3 3 0 rather than 3 3 1 would turn off headset mode).
Programming help
During any of the programming steps, press PROG/HELP again to hear a more detailed description
of the feature and related programming options.
Exiting programming mode
To exit programming mode, hang up.
Password
Your password may consist of 2–8 digits followed by # (0 cannot be the first digit). The password
will apply to station programming, voice mail retrieval and certain other features when activated. If
you prefer not to have to enter a password, enter 0 as your password or select one of the following
password levels:
Selection Result
0 No password required for access from any phone
1 Password required only for remote access, either off-premises
or from other stations within the system
2 Password always required