Esoteric N-05XD - MENU 2: Signal Processing Settings; PCM Filters, ΔΣ Frequency, Analog FIR, and ETHERNET LED

27
English
Digital filter setting during PCM playback
PCMF>***
Use this to set the digital filter during PCM playback.
Set it as desired.
o By default, the setting is OFF.
OFF
The digital filter is not used during PCM playback.
FIR
The FIR digital filter features a slow roll-off without pre-echo.
RDOT
This digital filter features a slow roll-off that uses a unique analog
interpolation technique with a fluency function.
ΔΣ frequency setting during PCM
playback
PCMΔΣ>***
The ΔΣ modulator operation frequency during PCM playback can be
set to 64, 128, 256 or 512.
Select the sound setting you prefer.
o By default, the setting is 512.
This sets the operation of the ΔΣ modulator as a frequency multiple
of 32, 44.1 or 48kHz.
Example:
When 512 is selected with a 96kHz audio source, the ΔΣ modulator
operates at 24.576MHz (48kHz × 512).
MENU 2
Analog FIR filter setting
AFIR>***
Use this to set the analog FIR filter.
Set it as desired.
o By default, the setting is OFF.
OFF
The analog FIR filter is not used.
ON
The analog FIR filter is used.
ETHERNET port LED setting
LanLED>***
Use this to set the ETHERNET port LED. When set to OFF, the
ETHERNET port LED will not light, reducing the impact on audio
quality.
o By default, the setting is OFF.
o Even when set to OFF, the LED will blink immediately after a LAN
cable is connected and while the unit is initializing after being
turned on (while “Initialize” displayed).
OFF
The ETHERNET port LED stays unlit.
ON
Lighting and blinking of the ETHERNET port LED are enabled.