33
English
Bluetooth connection
Cannot show device name.
e This unit does not support the display of symbols or double-
byte characters, including Japanese and Chinese.
Use only English letters and numbers for the names of
Bluetooth devices connected to this unit.
Cannot change connected Bluetooth device.
e This unit cannot have Bluetooth connections to multiple
Bluetooth devices at the same time.
To change the device connected with this unit by Bluetooth,
end the connection with the currently connected Bluetooth
device before connecting to another Bluetooth device.
Sound is not output, or the volume is low.
e Confirm that the volume is turned up on the other Bluetooth
device. If the volume of the audio being output is not turned
up, no sound might be heard from this unit.
Since this unit uses a microcontroller, external noise and other
interference can cause the unit to malfunction. If this occurs,
turn the unit off and wait about one minute before restarting
operation from the beginning.
Note about condensation
If this unit is brought from a cold outdoor environment into a
warm room, or the heater has just been turned on in the room
where it is located, for example, condensation might occur, result-
ing in improper operation. If this occurs, leave the unit on and
wait 1–2hours. This should enable normal operation.
Restoring factory settings
Settings are retained even if the power plug is disconnected.
Follow these procedures to restore the factory default settings and
erase all changes in memory.
1 Put the unit into standby.
If the unit is on, press the STANDBY/ON button to put it into
standby.
2 Press the STANDBY/ON button while holding
down the MENU button.
When “Setup CLR” (settings cleared) appears on the display,
release the MENU button.
To Next Page
Loading...
Need help?
General
