7
English
Before use
Included accessories
Check to be sure the box includes all the supplied accessories shown
below. Please contact the store where you purchased this product if
any of these accessories are missing or have been damaged during
transportation.
Power cord × 1
Remote control (RC-1334) × 1
Batteries for remote control (AA) × 2
Felt pads × 3
Owner’s manual (this document) × 1
Warranty card × 1
Note about pinpoint feet
High-precision metal pinpoint feet are attached to the bottom plate
of this unit.
The pinpoint feet and their stands are loose, but when the unit is
placed in position, it is supported by these pinpoint feet, which effec-
tively disperse vibrations
Chassis
Pinpoint foot (metal)
Foot-stand (metal)
After
placement
o Apply the included felt pads to the bottoms of the foot-stands to
avoid scratching the surface where the unit is placed.
o This unit is very heavy, so take care to avoid injury during
installation.
o Do not place anything on top of the unit.
o Do not install this unit in a location that could become hot. This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment. Moreover, do not
place it on top of an amplifier or other equipment that gener-
ates heat. Doing so could cause discoloration, deformation or
malfunction.
o In order to enable good heat dissipation, leave at least 20cm (8")
between this unit and walls and other equipment when installing
it. If you put it in a rack, for example, leave at least 5cm (2") open
above and 10cm (4") open behind it.
Failure to provide these gaps could cause heat to build up inside
and result in fire.
o Place the unit in a stable location.
o Do not move the unit during use.
o Be careful to avoid injury when moving the unit due to its weight.
Have someone help you move it if necessary.
o The voltage supplied to the unit should match the voltage as
printed on its back. If you are in any doubt regarding this matter,
consult an electrician.
o Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock. If a foreign object should
get into the unit, contact your dealer.
o When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord.
Precautions for use
To Next Page
Loading...
Need help?
General
