ESS XT-3 - Trigger; To Engage;Disengage the Trigger; To Clean the Trigger

ESS XT-3 OWNER’S MANUAL
Trigger
The trigger turns the spray on and o.
It can be connuously held for operaon or it can be locked in place.
To engage/disengage the trigger:
1. Depress the trigger up towards the body of the spraywand to start spraying.
2. To keep spraying, either keep holding the trigger or lock it in place by pulling
up the lock and hooking the trigger.
3. To stop spraying when the trigger is not locked, let go of the trigger.
To clean the trigger:
1. Unthread the brass bolt on the top of the spraywand with a 5/8”socket
wrench. Be careful not to lose the spring, plunger, copper washer, and small
brass bushing inside the trigger. Note how they t inside so they may be
replaced properly.
2. Check inside the trigger for blockage. Clean out any debris with compressed air
or warm, soapy water.
3. Replace the spring and plunger; rethread the brass bolt into the top of the
spray gun unl ght.
10
Brass Bolt
Pull Trigger Lock for-
ward to engage
Depress trigger
to spray