ESS XT-3 - Operating Instructions

ESS XT-3 OWNER’S MANUAL
Operang Instrucons
Steps for Operaon
1. Prepare the tank mix.
2. Connect the twin line hose to the front panel.
3. Connect the twin line hose to the liquid and air leaders on the handgun. If using
the plasc bole, connect the gray hose of the plasc bole hose assembly instead
of the gray hose of the twin line hose to the liquid leader.
4. Plug the power cord into an appropriate receptacle. Turn on the XT-3 air
compressor.
5. Engage the trigger and spray.
Cauons:
ESS recommends that you use
an outlet with
a Ground-Fault Circuit
Interrupter (GFCI).
Do not operate the
XT-3 in standing water.
Do not immerse the
XT-3 compressor.
If you use a pacemaker, use our
electrostac sprayer at our own
risk.
6
One of these labels is placed on the charger of
all spraywands.
LED LIGHT MODE
MAIN CHARGING
MODE
FINISHED
BATTERY PACK HAS
SHORT CIRCUIT OR
CONNECTOR HAS
SHORTED
When charging is complete LED Light
will automacally change to GREEN.
Remove AC plug and DC plug.
See owners manual for more
informaon.