ESS XT-3 - Spraywand Service Parts

ESS XT-3 OWNER’S MANUAL
XT-3 Troubleshoong Guide
First step determine where the clog is:
• The base unit
• Liquid hose quick connecons
• The ow disc and lter
• The Sprawand.
Remove the Fing on the back of
the gun that looks like this, (could
be brass or stainless steel) We will
refer to this as the “removed ng”
The Base Unit:
1. Unplug the blue hose from the
base unit
2. Plug the removed ng into
the base unit
3. Fill the tank at least half full
with water, turn on sprayer.
a. Make sure the pressure
relief valve on the compressor
is well-seated and not leaking.
b. Make sure pressure is building
up inside the tank, with the
compressor running, by pulling
slightly on the tank relief valve.
4. Water should spray out the
“removed ng” that has been
plugged directly into base unit.
If water sprays out of the
“removed ng” then the clog is
not in the base unit.
Removed Fing
3
b
1
a
2