26
6.2
6.26.2
6.2 Measurement of Sin
Measurement of SinMeasurement of Sin
Measurement of Single Lens
gle Lensgle Lens
gle Lens
(1)
Place the lens on the lens stand.
Lower the lens holder softly on the lens.
The screen as shown on the right appears.
(2)
Bring the cross cursor to the alignment mark by
moving the lens. The message “Alignment OK
Alignment OKAlignment OK
Alignment OK”
appears on the screen when alignment completes.
If the lens is the cylindrical one, rotate the lens to
fit the axis direction.
(3)
Overlap the cross cursor and the alignment mark by
moving the lens. When they overlap, the message
“Marking OK
Marking OKMarking OK
Marking OK” appears to indicate that the marking is
ready to be carried out.
S, C, A and prism are stored in memory by pressing the
Memory/ ADD switch.
The color of the measurement value area is reversed,
and the values are fixed.
※
In case of setting “Auto Memory
Auto MemoryAuto Memory
Auto Memory” on the Setup
screen as “On
OnOn
On”, the measurement values are
stored in memory automatically after the message
“Marking OK” appears.
In case of deleting the data stored in memory,
press .
※
In case of printing it out, press .
Do not give strong impact to a lens when lowering the lens holder.
When rising the lens holder, make sure that it is moved to the top and locked.
The alignment mark represents the optical center of the lensmeter and the
cross cursor represents the optical center of the lens.
NOTE
NOTENOTE
NOTE
To Next Page
Loading...
Need help?
General
