Details of each setting item - [Screen 2]
• SE: Set the output of SE value.
◦ On: Output the representative value of SE on print-out, data screen and communication output
(XML format only).
◦ Off: No output of SE value.
• Rest: Select the output of residual astigmatism.
◦ On: Display the residual astigmatism.
◦ Off : No astigmatism is displayed.
• W-D (cm): Set the work distance.
The near pupil distance is automatically computed after the measurement and displayed on the
screen.
• Target: Select the brightness of the target.
◦ Bright: Brighten the target.
◦ Middle: Normal setting.
◦ Dark: Darken the target.
• Brightness: Adjust/ change the brightness of the LCD monitor.
• Save (min): Select the switchover time to activate the power saving function (unit is min.).
• RS-232C: Select the baud rate when sending the measurement data to the exterior computer.
• Buzzer: Set if activating the buzzer at the time of switching to the power saving function or not.
◦ On: Buzzer is on.
◦ Off: Buzzer is off.
• Option: It is switched to each option screen when selecting the item to be set on the option of the
setup screen.
The screen of each option and the details.
To Next Page
Loading...
Need help?
General
